油煙罩怎么清洗及清洗注意事項！

發布人：http://www.rdhw.com.cn   發布時間：2024-01-13 11:36:21

油煙罩是餐廳、酒店、學校等大型廚房必備工具，相信大家都有見過，它是用來吸取油煙的工具，油煙罩的出現解決了在烹飪時產生大量油煙的困擾，但是由于使用時間長，油煙罩里面或者表面會形成油垢，從而會影響廚房的環境衛生且有異味，也會影響油煙罩排煙效果不佳，所以建議大家要定期清洗，在清洗油煙罩要深入清洗，簡單的處理清洗效果也不明顯，油煙罩的清洗也是大家很困惑的問題，今天長沙不銹鋼油煙罩廠家就給大家介紹一下油煙罩清洗方法吧。

The oil fume hood is a necessary tool for large kitchens such as restaurants, hotels, and schools. I believe everyone has seen it before. It is a tool used to absorb oil fumes. The appearance of the oil fume hood solves the problem of producing a large amount of oil fumes during cooking. However, due to long-term use, oil stains may form inside or on the surface of the oil fume hood, which can affect the environmental hygiene and odor of the kitchen, and also affect the smoke exhaust effect of the oil fume hood. Therefore, it is recommended to clean it regularly, When cleaning the oil fume hood, it is necessary to thoroughly clean it, and simple treatment may not have a significant cleaning effect. The cleaning of the oil fume hood is also a confusing problem for everyone. Today, the stainless steel oil fume hood manufacturer in Changsha will introduce the cleaning method for the oil fume hood.

人工進入法：對于40 cm以上的平行油煙管道可人工鉆孔清理，此方法勞動強度大，需注意加強通風，配備低壓(36伏特)照明電源。

Manual entry method: For parallel oil fume pipelines above 40 cm, manual drilling and cleaning can be carried out. This method is labor-intensive and requires attention to strengthening ventilation, equipped with low-voltage (36 volt) lighting power supply.

拆卸法：當煙氣管道小于40平方厘米時，采用此方法，當勞動力不能進入時。技術人員根據現場的實際情況，在一定距離處移除一段煙道，并將其清潔到兩側。該方法效果好，難度大。大，成本高。

Dismantling method: When the flue gas duct is less than 40 square centimeters, this method is used when labor cannot enter. Technicians remove a section of flue at a certain distance based on the actual situation on site and clean it on both sides. This method is effective and difficult. Large, high cost.

開孔法：本方法適用于油煙管道，不能人工進入，拆卸困難。技術人員使用無火花工具在管道上開一個或多個孔?？椎拇笮　⒕嚯x和數量取決于現場情況。清理油污后，恢復管道密封。

Opening method: This method is suitable for oil fume pipelines and cannot be manually entered, making disassembly difficult. Technicians use spark free tools to drill one or more holes in the pipeline. The size, distance, and number of holes depend on the site conditions. After cleaning the oil stains, restore the pipeline seal.

機器設備清洗法：該方法用于油煙管道的清洗時間較短。先在管道中噴灑清潔劑以軟化油，然后用30米長的電軟軸刷清洗油。這種方法用于30厘米平方的垂直煙道，即無法實際進入和無法拆除的隱蔽煙道。這是不容易清潔和容易積累的油，以縮短清潔周期。

Machine equipment cleaning method: This method has a shorter cleaning time for oil fume pipelines. First, spray cleaning agent into the pipeline to soften the oil, and then use a 30 meter long electric soft shaft brush to clean the oil. This method is used for vertical ducts of 30 centimeters square, which are concealed ducts that cannot be physically entered or removed. This is an oil that is difficult to clean and easy to accumulate, in order to shorten the cleaning cycle.

空降法：此法主要用于清洗50公分見方以上的豎油煙管道，技術人員先拆下管道的上截和下截，在油煙管道上方固定高空繩，系上帶，技術人員從上下清洗豎油煙管道內的油污。此法危險性較大，技術性強，費用較高，清理效果好。由于豎油煙管道一般積油較少一年清洗一次較好。

Airborne method: This method is mainly used to clean vertical oil fume pipelines with a diameter of more than 50 centimeters. Technicians first remove the upper and lower sections of the pipelines, fix high-altitude safety ropes above the oil fume pipelines, fasten safety belts, and clean the oil stains inside the vertical oil fume pipelines from top to bottom. This method is highly dangerous, technical, costly, and has a good cleaning effect. Due to the fact that vertical oil fume pipelines generally have less oil accumulation, it is better to clean them once a year.