通風管道與附件的裝置的特點

發布人：http://www.rdhw.com.cn   發布時間：2017-08-29 16:53:44

1、 在一道密閉閥門工程口部的管道與配件,應選用厚2~3mm的鋼板焊接制造.其焊縫應飽滿、均勻、緊密.

1, in the first closed valve to the Engineering Department of the pipe and fittings, should be used thick 2~3mm steel plate welding, welding seam should be full, uniform, tight

2、染毒區的通風管道應選用焊接銜接.通風管道與密閉閥門應選用帶密封槽的法蘭銜接,其觸摸應平坦;法蘭墊圈應選用整圈無接口橡膠密封圈.

2. The ventilation duct in the contaminated area shall be welded and connected. The ventilation pipe and the sealed valve shall be connected with flanges with sealing grooves. The touch shall be flat. The flange gasket shall be made of a whole circle without interface rubber sealing ring

3、 主體工程內通風管與配件的鋼板厚度應契合規劃請求.

3. The thickness of the steel plate of the ventilation pipe and fittings in the main project shall be consistent with the plan request

當規劃無具體請求時.鋼板厚度應大于0.75mm.

When planning has no specific request, the steel plate thickness should be greater than 0.75mm.

4、 工程測壓管在防護密閉門外的一端應設有向下的彎頭;

4. The engineering pressure measuring pipe shall be provided with a downward elbow at one end of the protective airtight door;

另一端宜設在通風機房或控制室.并應裝置球閥.經過防毒通道的測壓管,其接口應選用焊接.

The other end shall be located in the ventilation room or the control room, and the ball valve shall be installed

5、 通風管的測定孔、洗消取樣管應與管一起制造.測定孔和洗消取樣管應封堵.

5. The measuring hole of the vent pipe and the decontamination sampling tube shall be fabricated together with the tube. The measuring hole and the decontamination sampling tube shall be sealed

6、 通風管內氣流方向、閥門啟閉方向及開啟度,應標明明晰、精確.

6, ventilation pipe airflow direction, valve opening and closing direction and opening degree should be marked clear and accurate

本文由山東通風管道整理發布，您是不是對這些內容有所了解了呢?更多的內容請點擊：http://www.rdhw.com.cn/我們會有更多精彩內容等你查看。

This article is arranged and released by Shandong ventilation pipe. Do you know something about it? Please click on http://www.rdhw.com.cn/ for more content. We will have more wonderful content for you to check.