空調山東通風管道清洗方法!

發布人：http://www.rdhw.com.cn   發布時間：2019-05-28 17:24:55

　　空調山東通風管道清洗方法!

　　Central air conditioning Shandong ventilation duct cleaning method!

　　空調通風系統主要包括風管、新風風管、空調風箱、送風口、空氣密封口、空氣處理單元和風機盤管?？照{(diào)系統在長期運行過程中容易發生積灰、堵塞等現象，造成微生物滋生、風阻、機組容量下降、壓縮機耗電量增加等問題。解決這些問題根本的辦法是徹底清潔空調通風系統。但是，如果清洗不符合規范的技術要求，通風管道內的灰塵、細菌和微生物將給周圍環境、清洗人員、空調用戶和空調設備帶來極大的危害。

　　The central air conditioning ventilation system mainly includes air duct, fresh air duct, central air conditioning bellows, air supply outlets, air sealing outlets, air handling units and fan coil units. Air conditioning system is prone to dust accumulation and blockage during long-term operation, which results in microbial breeding, wind resistance, unit capacity decline and compressor power consumption increase. The most fundamental way to solve these problems is to thoroughly clean the air conditioning and ventilation system. However, if cleaning does not meet the technical requirements of the specification, dust, bacteria and microorganisms in the ventilation duct will bring great harm to the surrounding environment, cleaning personnel, air conditioning users and air conditioning equipment.

　　空調水系統清洗

　　Cleaning of air conditioning water system由于空調管道內表面附著的主要是Ca2、Mg2、Fe2等化合物即為垢，屬于中性。采用8‰~10‰中性除垢劑、緩蝕劑、鍍液清洗三次。一個連續循環持續12小時，第二個連續循環持續6小時，第三個連續循環持續1小時。及時檢測水質和水管表面狀況。一般情況下清洗三次即可清洗干凈，對長期未清洗的空調管道在清洗時應適當延長清洗時間。

　　Because the inner surface of air-conditioning pipeline is mainly adhered to Ca2, Mg2, Fe2 and other compounds, that is, scale, belongs to neutral. Using 8 ~10 neutral scale remover, corrosion inhibitor, bath cleaning three times. The first continuous cycle lasts 12 hours, the second continuous cycle lasts 6 hours and the third continuous cycle lasts 1 hour. Inspect water quality and surface condition of water pipe in time. Normally, cleaning can be done three times, and the cleaning time should be prolonged appropriately for long-term uncleaned air-conditioning pipelines.

　　冷卻水系統清洗

　　Cleaning of cooling water system

　　因?yàn)榇蠖鄶?shù)的冷卻水系統是開環系統,冷卻水和長期暴露在空氣中,二氧化碳,二氧化硫,二氧化氮,氧氣在空氣和其他氣體溶于水和酸和強氧化性(如冷卻水泵葉輪汽蝕現象發生),隨著時間的推移,冷卻水管,填料表面,水板形成一個包含嗜肺軍團菌、b -溶血性鏈球菌,藻類,O2致病微生物如附件,管道腐蝕嚴重，環境污染(酸雨下冷卻塔附近)。因此，如果使用酸性清洗劑，則使用5‰的弱酸除鱗劑、緩蝕劑、涂料溶液清洗三次，清洗程序如上。

　　Because most cooling water systems are open-loop systems, cooling water and long-term exposure to air, carbon dioxide, sulfur dioxide, nitrogen dioxide, oxygen in air and other gases dissolved in water and acid and strong oxidation (such as cooling water pump impeller cavitation phenomenon occurs), over time, cooling water pipes, filler surface, water plate formed a containing Legionella pneumophila, B-hemolytic streptococcus, algae, O 2. Pathogenic microorganisms such as accessories, pipeline corrosion is serious, environmental pollution (near cooling tower under acid rain). Therefore, if acidic detergent is used, then 5 weak acid descaling agent, corrosion inhibitor and paint solution are used to clean three times. The cleaning procedure is as follows.

　　通風系統清洗

　　Ventilation system cleaning

　　山東通風管道系統的清洗是清洗工作中的關鍵難點，因?yàn)橥L(fēng)管道一般都在天花板上，即使不在天花板上，因?yàn)楣艿朗敲芊膺B接的，也很難清洗，經常采用機械清洗的方法?，F(xiàn)在常見的清洗方法的帆布軟連接裝置將在通風管道檢測機器人或氣動機器人,通過管道機器人控制箱控制,通風管道清潔機器人,塵含量多的管道系統使用管徹底垃圾收集器的收集管,以防止二次污染。

　　The cleaning of Shandong ventilation pipeline system is the key difficulty in cleaning work, because the ventilation pipeline is usually on the ceiling, even if not on the ceiling, because the pipeline is sealed and connected, it is difficult to clean, and mechanical cleaning method is often used. Nowadays, the common cleaning method of canvas soft connection device will detect robots or pneumatic robots in ventilation pipes, control them through the control box of the pipeline robot, clean the ventilation pipes, and use the collecting pipes of the exhaustive garbage collector in the dust-rich pipeline system to prevent secondary pollution.

　　表的冷卻、加熱、加濕器的表面、冷凝盤的表面，回風口清洗表的冷卻、加熱、加濕器，回風口清洗不僅能改善空氣質量，而且具有較強的效果。常用的清洗方法是使用空氣射流清洗劑，然后用高壓水或空氣進行清洗，使污物迅速溶解并被沖走，然后用低壓水沖洗干凈。附著在表面冷卻器表面的污染物含有溶血性鏈球菌等致病微生物，大部分翅片清洗后進入冷凝水板，長期積累會對水板造成二次污染，并伴有異味。因?yàn)檫@個冷凝盤是清洗過的，也不能忽視。常用的冷凝盤清洗方法是在冷凝盤上噴灑清洗劑，然后用清水沖洗。

　　Cooling, heating, humidifier surface, condensation plate surface, cooling, heating and humidifier of return air outlet cleaning table, return air outlet cleaning can not only improve air quality, but also have a strong energy-saving effect. The common cleaning method is to use air jet cleaning agent, and then use high-pressure water or air to clean, so that the dirt quickly dissolved and washed away, and then washed with low-pressure water. Contaminants attached to the surface of the cooler contain pathogenic microorganisms such as Streptococcus haemolyticus. Most of the fins are washed and enter the condensate plate. Long-term accumulation will cause secondary pollution of the water plate, accompanied by odor. Because this condensation plate has been cleaned and can not be ignored. The common cleaning method of condensation plate is spraying cleaning agent on the condensation plate, and then rinsing with clean water.

　　空調山東通風管道清洗方法!以上是空調冷水機組水系統和通風系統的清洗方法。只有關注空調系統的管理,及時清理和維護,才能確保空調設備和設施處于良好狀態,增加了生活的各種各樣的設備和設施,確保設備的正常和運行。

　　Central air conditioning Shandong ventilation duct cleaning method! The above is the central air conditioning chiller water system and ventilation system cleaning method. Only by paying attention to the management of the central air-conditioning system and timely cleaning and maintenance, can we ensure that the central air-conditioning equipment and facilities are in good condition, increase all kinds of equipment and facilities in life, and ensure the normal and safe operation of the equipment.