通風管道施工質量控制措施研究

發布人：http://www.rdhw.com.cn   發布時間：2018-09-20 11:42:15

隨著社會經濟的發展，人民物質生活水平的不斷提高享受現代化設施設備的愿望不斷加強，空調系統得到了越來越多的應用，空調通風管道系統的合理性，對提高整個社會的能源的有效利用率，減少能源的浪費，起著重要的作用。如何在保證既有建筑功能和居住環境質量的同時，又能兼顧到性和經濟性，使改造工程得到用戶的認可，更有利的促進改造。這就需要一種全新的評價方法，而不是傳統的只考慮性或者經濟性的單一評價，來體現改造的優越性。目前，隨著通風工程施工工藝的不斷提高，通風系統對風管制作和安裝具有很高的要求，但是還是存在影響施工質量的問題存在。本文將就辦公樓通風系統的安裝施工質量控制展開探討。

With the development of society and economy, people's desire to enjoy modern facilities and equipment has been strengthened. Air conditioning system has been used more and more. The rationality of air conditioning and ventilation duct system plays an important role in improving the effective utilization rate of energy and reducing the waste of energy. Use. How to ensure the existing building functions and living environment quality at the same time, but also to take into account the energy-saving and economic, so that energy-saving renovation project has been recognized by users, more conducive to promoting energy-saving renovation. This requires a new evaluation method, rather than the traditional single evaluation which only considers energy-saving or economic, to reflect the advantages of energy-saving transformation. At present, with the continuous improvement of ventilation engineering construction technology, the ventilation system has a high requirement for air duct production and installation, but there are still problems affecting the construction quality. This article will discuss the quality control of installation and construction of ventilation system in office buildings.

1.施工前準備工作

1. preparation before construction

   
   

凈化風管的質量直接關系到系統是否達到設計參數和正常使用要求，其制作一般采用工廠集中制作和現場制作兩種方式。無論采用哪種制作方式，都要保證制作場地的潔凈和封閉，較好選用水泥地面或地面鋪設金屬鋼板，其面積不得小于100m?，且滿足采光和照明條件，制作完成的凈化風管要進行堆放，并進行看管;如果選用現場預制時，要保證預制完成后的風管能夠及時運施工現場，盡量減少風管搬運的距離，這樣可以避免運輸過程中對風管的污染。

The quality of the purifying duct is directly related to whether the system meets the design parameters and normal operation requirements. It is usually made in two ways: factory centralized production and on-site production. No matter which method of production is adopted, the cleanliness and closure of the site should be guaranteed. It is better to use cement ground or ground to lay metal plate, its area must not be less than 100m?, and to meet the lighting and lighting conditions, the purified air duct should be stacked and cared for; if prefabricated site is selected, it should be guaranteed in advance. The finished duct can be transported to the construction site in time to minimize the distance of the duct, which can avoid the pollution of the duct in the process of transportation.

3.注意事項

3. points for attention

(1)風管存放

(1) air duct storage

對于預制而成的風管，要做好存放工作，應將管口用塑料布等密封薄膜進行密封，堆放過程中，要分類編號堆放，盡量選擇室內存放，當條件所限，需要在露天堆放時，要做好地面處理，并做好防雨、防風沙等措施。

For the prefabricated air duct, to do a good job of storage, first of all should be sealed with plastic cloth and other sealing film, stacking process, to classify and number stacking, as far as possible to choose indoor storage, when conditions are limited, need to be stacked in the open air, to do a good job of ground treatment, and do a good job of rain, sand and other measures.

(2)風管安裝前清洗

(2) cleaning before air duct installation.

在安裝風管、靜壓箱及其他部件時，需要對風管進行徹底的清洗，確保板材清洗后，表面無腐蝕，干燥后不吸塵，這就要選擇質量滿足要求的清洗劑，且清洗劑對人體無害。當清洗完成后，要用清水沖洗，較后擦干表面的水珠，也可進行自然風干，較后做好封口處理。

When installing air duct, static pressure box and other parts, it is necessary to thoroughly clean the air duct to ensure that the surface of the plate is not corroded after cleaning, and no dust is collected after drying. Therefore, it is necessary to select the cleaning agent that meets the quality requirements, and the cleaning agent is harmless to human body. When the cleaning is completed, rinse with clean water, and finally wipe the surface of the water droplets, but also for natural air-drying, finally do a good job of sealing treatment.

(3)風管安裝后的防護

(3) protection after installation of duct

為了防止施工現場的灰塵或雜物進入清洗過的風管中，需要施工人員進行風管安裝后，對暫時不安裝的風管口、過濾口等敞開口要用塑料布妥善包扎。

In order to prevent dust or sundries from entering the cleaned air duct at the construction site, it is necessary for the construction personnel to install the air duct and wrap the open openings such as the air duct opening and the filter opening which are temporarily not installed properly with plastic cloth.

辦公室的通風管道安裝涉及到設計、安裝、生產工藝、設備供應等各個內容，如果控制不好，可能導致整個系統不能達到設計要求，較終影響到人們的使用。因此，在通風管道的安裝過程中，安裝人員要嚴格按照施工工藝進行安裝，并進行質量控制工作，只有這樣才能保證風管的安裝質量，達到使用要求。

The installation of ventilation pipes in office involves design, installation, production process, equipment supply and other aspects. If the control is not good, the whole system may not meet the design requirements, and ultimately affect the use of people. Therefore, in the process of installation of ventilation duct, the installation personnel should strictly follow the construction technology and carry out quality control work, only in this way can the installation quality of the duct be guaranteed to meet the use requirements.